Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1.7.Operating
Steps to follow:
1. Connect the end wiring of the heater to the
socket, which is on the metallic base (piece 12).
2. Turn the tap on.
3. Turn the tap off when you see that the
water level is on the heater.
Rev. 020113
1.8. Switch on
Steps to follow:
1. Switch on the green switch (piece 10). This
will light showing that the still is connecting
to the power point. The warning light will
also light (piece 9) showing that the water
supply is not enough.
2. Turn the tap on slowly until the pilot
(piece 9) turn off.
• Before few minutes, the heater will be
getting red and the boiling will start. The
stilled water goes out through the outlet
(piece 4).
• If water steam went out through steam
hole (piece 2), you would have to increase
water supply.
· You should clean the still regularly. So, in
this way, the results will be better and you
can get a still more durable.
Pag: 10
Publicidad
Tabla de contenido
