Publicidad
Idiomas disponibles
Idiomas disponibles
2610056809 GSR GSB18V-975C 03-21.qxp_GSB18V-975C 3/5/21 4:33 PM Page 10
Disconnect battery pack from tool before making any assembly, adjustments or
changing accessories. Such preventive safety measures reduce the risk of starting
the tool accidentally.
Do not use the power of the
drill while grasping chuck to
loosen or tighten bit. Friction burn or hand
injury is possible if attempting to grasp the
spinning chuck.
Inserting Bits
Move reverse switch lever to the center "OFF"
position. Remove battery pack and turn the
mode selector switch to the drilling
position. Rotate the chuck sleeve counter-
clockwise viewing from chuck end, and open
chuck to approximate drill bit diameter. Insert a
clean bit up to the drill bit flutes for small bits, or
as far as it will go for large bits. Close chuck by
rotating the chuck sleeve clockwise and securely
tighten by hand (Fig. 2). Return the mode
selector switch to desired position.
Belt Clip
When the tool is attached to
the belt, position yourself to
avoid entanglement with surrounding objects.
Unexpected entanglement could cause the tool to
fall resulting in injury to the operator or
bystanders.
The belt clip accessory will allow you to
conveniently attach your tool to your belt. This
feature will allow you to have both hands free
when climbing a ladder or moving to another
work area.
The belt clip can be attached to either side of
the tool by securing it with a mounting screw.
Always make sure you securely tighten the
mounting screw before use (Fig. 3).
To use clip, turn tool upside down and attach to
your belt.
10
Assembly
SAVE THESE INSTRUCTIONS
CHUCK SLEEVE
CLOSE
DRILL BIT
SCREWDRIVER BIT
OPEN
BIT HOLDER
BELT CLIP
Publicidad
