GE AEH12 Manual De Instrucciones página 11

INSTALL THE CASE IN THE
8
WINDOW
Open the window and mark the centerline
A
of the window sill.
B Carefully place the case on the window
stool and align the center mark on the
bottom front with the centerline of the sill.
C Pull the window down behind the top
mounting rail.
NOTE: Do not shut the window so tightly that
movement of the accordion panels is
restricted.
Select the position that will place the sill
D
supports near the outermost point on the
sill. Place the short side of the sill supports,
on the case bottom, toward the window.
Attach the sill supports to the case track
hole in relation to the selected position
using 2 Type B screws in each support.
E Adjust the bolt and the nut in each
support so that the case is installed with a
slight tilt to the outside. Use a level; about
1/2 bubble will be the correct case slant to
the outside.
CAUTION:
bolts do not contact the window sill,
or if you have a window without a sill,
you must order accessory kit RAK87 to
properly install this air conditioner. Call
800.626.2002 or visit ge.com.
Installation Instructions
Long side
of sill
supports
OUTSIDE
If the sill support
INSTALL THE CASE IN THE
8
WINDOW (CONT.)
Secure the case to the window sill by
F
using 3 Type D screws.
Sill
support
Pull the accordion panels to each window
G
sash track. Attach them on each side to the
window sash and the window sill using
4 Type C screws.
11