GE AEH12 Manual De Instrucciones página 5

Cool Mode
Use the Cool mode at Low, Med, High or Auto Fan
Speed for cooling. Use the Temperature Increase L /
Decrease M pads to set the desired temperature
between 64°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the
room temperature. The compressor will cycle on
and off to keep the room at the set level of comfort.
Delay 1–24hr
Set the thermostat at a lower number and the indoor
Delay timer
air will become cooler. Set the thermostat at a higher
Decrease
number and the indoor air will become warmer.
Mode select
NOTE: If the air conditioner is off and is then turned on
Fan speed
while set to a Cool setting or if turned from a fan setting
Decrease
to a Cool setting, it may take approximately 3 minutes
Temperature
set Increase
for the compressor to start and cooling to begin.
and Decrease
Energy Saver Mode
Controls the fan.
ON— The fan will cycle on and off with the
compressor. This results in wider variations of room
temperature and humidity. Normally used when the
room is unoccupied. NOTE: The fan may continue to run
for a short time after the compressor cycles off.
Fan Only Mode
Use the Fan Only Mode at Low, Med or High fan
speed to provide air circulation and filtering
without cooling. Since fan only settings do not
provide cooling, a Set temperature cannot be
Auto Fan Speed
Set to Auto fan speed for the fan speed to
automatically set to the speed needed to provide
optimum comfort settings with the set temperature.
Air Direction
Use the levers to adjust the air direction left and
right.
Fingertip pressure on the louver banks adjusts the
air direction up or down.
Remote Control
I
To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.
I
The remote control signal has a range of
up to 20 feet.
Cooling Descriptions
For Normal Cooling— Select the Cool mode and
High or Med fan with a middle set temperature.
For Maximum Cooling— Select the Cool mode
and High fan with a lower set temperature.
For Quieter & Nighttime Cooling— Select the
Cool mode and Low fan with a middle set
temperature.
Do Not Operate in Freezing Outdoor Conditions
This cool-only air conditioner was not designed for
freezing outdoor conditions. It must not be used in
freezing outdoor conditions.
OFF— The fan runs all the time, while the
compressor cycles on and off.
entered. The room temperature will appear
in the display.
NOTE: Auto Fan Speed cannot be used when in the
Fan Only Mode.
If the room needs more cooling, the fan speed
will automatically increase. If the room needs less
cooling, the fan speed will automatically decrease.
NOTE: Auto Fan Speed cannot be used when in the
Fan Only Mode.
I
Make sure nothing is between the air conditioner
and the remote control that could block the
signal.
I
Make sure batteries are fresh and installed
correctly as indicated on the remote control.
ge.com
5