AUDIO SETTINGS
Speaker output settings
Select the output setting for the speakers [SPK/PRE OUT], base on the
speaker connection method.
Connection via lineout terminals
For connections through an external amplifier. ( 21)
Setting on
[SPK/PRE OUT]
FRONT
REAR/REAR
Front speakers output
REAR/SUB.W
Front speakers output
SUB.W/SUB.W
Front speakers output
Connection via speaker leads
For connections without using an external amplifier. However, with this
settings you can also enjoy the subwoofer output. ( 21)
Setting on
[SPK/PRE OUT]
L (left)
REAR/REAR
Rear speakers output
REAR/SUB.W
Rear speakers output
SUB.W/SUB.W
Subwoofer output
If [SUB.W/SUB.W] is selected:
– [HIGH 120HZ] is selected in [SUB.W LPF] and [THROUGH] is not available.
– [R01] is selected in [FADER] and selectable range is [R06] to [00]
Audio signal through lineout terminal
REAR/SW
Rear speakers output
Subwoofer output
Subwoofer output
Audio signal through rear speaker lead
R (right)
Rear speakers output
Rear speakers output
(Mute)
DISPLAY SETTINGS
1
Press and hold
.
2
Turn the volume knob to select an item (see the following table),
then press the knob.
3
2
Repeat step
until the desired item is selected/activated or follow
the instructions stated on the selected item.
4
Press
to exit.
To return to the previous setting item, press
DISPLAY
DIMMER
Dim the display and buttons illumination.
OFF: Dimmer is turned off.
ON: Dimmer is turned on. Brightness changes to [NIGHT] setting.
( [BRIGHTNESS])
DIMMER TIME: Set the dimmer on and off time.
1 Turn the volume knob to adjust the [ON] time, then press the knob.
2 Turn the volume knob to adjust the [OFF] time, then press the knob.
(Default: [ON]: 18:00 or 6:00 PM
[OFF]: 6:00 or 6:00 AM)
AUTO: Dimmer turns on and off automatically when you turn off or on the car
1
headlights. *
BRIGHTNESS Set the button, display and USB input terminal brightness for day and night
separately.
1 DAY / NIGHT: Select day or night.
2 Select a zone.
3 Set the brightness level (00 to 31). (Default: DAY: 31 ; NIGHT: 15)
*
1
The illumination control wire connection is required. ( 21)
.
Default: XX
13
ENGLISH