Publicidad
Idiomas disponibles
Idiomas disponibles
26
P
lacing and Leveling
Please ensure that transit restraint has been removed before operating your machine.
1
Place the machine on a flat and firm surface which allows proper clearance.
We suggest a minimum clearance of 2 cm to the right
side and left sides of the machine for ease of
installation.
At the rear, a minimum clearance of 10 cm is
suggested.
Caution
If the washer is installed on a uneven, weak or tilted floor causing excessive vibration,
spin failure or "
It must be placed on a firm and level floor to prevent spin failure.
2
Set rear legs
Remove the level and tilt the washer forward (pivot on
front legs) about 4 to 6 inches and gently lower the rear
legs back onto the floor.
This action will set rear leg adjustments to correspond
to front settings.
3
Check that the machine is level
Open the lid and look from above to see if it is
same as shown.
4
Leveling the machine
Lift the front of the washing machine and twist the
Adjustable Leg until the surface bubble is placed in the
center.
Caution
If the power is supplied from a cord extension set or generator, the cord extension set or electrical
portable outlet device should be positioned so that it is not exposed to splashing or ingress of moisture.
" error can happen to it.
more than 10 cm
more
than
2 cm
Top view of the machine
Lower
more than
2 cm
Raise
Publicidad
