LG WF-T1477TP Manual Del Usuario página 28

28
C
onnecting Water Supply Hose
Normal Type (Normal tap without thread & one touch type inlet hose.)
1
Separate Middle connector from Water Supply Hose
Separate Middle connector from the Water Supply Hose by
pulling the Pressing Rod and the Pressing Handlre that is
attached to the Water Supply Hose.
2
Loosen the fixed nuts to connect the connector to the tap
Untighten the screw of the connector so that the
tap can be placed in middle.
Note
In case tap is too large.
If the tap diameter is too large or is square,
untighten the 4 screws and remove the guide
plate. Then follow step1.
3
Fixing Connectors to the Tap
Push the upper connector up till the rubber packing is in
tight contact with the tap. Then tighten the 4 screws.
4
Fixing Upper Connector and Middle Connector
Remove the fixed sticker in between the Upper and Middle
Connectors. Tighten the connectors by holding one
connector and twist middle connector to the right.
5
Connecting Middle Connector and water Supply Hose
Press down the pressing rod of the Water Supply
Hose whick was separated from middle connector (refer to
Step 1) and then join it to the middle connector.
6
Check for water leakage
After connecting the hose, open the tap to check for any water
leakage.
If the connection leaks, close the tap and start again from step 1.
If you skip step 1, water leakage may occur.
Middle
Connector
Guide plate
Connector
Connector
Middle
Connector
Fixed sticker
Pressing rod
Water Supply Hose
Fixed Sticker
Pressing Handle
Pressing Rod
Water Supply Hose
Rubber packing
screw
Fixed sticker
Rubber packing
Connector
Middle
Connector
Pressing handle