American Gardener ReadyHedger RH30 Manual De Instrucciones página 3

ASSEMBLY
ASSEMBLING FRONT HANDLE
The unit comes assembled with the exception of the front accessory handle. DO
NOT UNDER ANY CIRCUMSTANCES USE THE TRIMMER UNTIL THE FRONT
ACCESSORY HANDLE IS INSTALLED.
To assemble the front accessory handle, locate the included hex wrench and two
hex screws. Align the handle over the insert nuts. See Figure 1.
Place hex screws into holes of handle and tighten until hex nuts stops turning – DO
NOT OVER TIGHTEN HEX SCREWS OR YOU MAY BREAK THE HOUSING!
See Figure 2.
Figure-1
Figure-2
5
OPERATIONS
ATTACHING EXTENSION CORD
The unit has an extension cord retainer built into the back of the housing that will
help keep the extension cord from becoming unplugged from the unit during use.
To use the cord retainer, create a loop of the extension cord and feed it through the
slot in the housing. See Figure 3. The extension cord loop should hook over the
tab on the housing.
Pull on the extension cord loop so that it tightens around the hook with the cord
pinched against itself in the housing slot as in Figure 4.
Once the cord is retained in the handle, plug the receptacle end of the cord into the
pigtail cord of the trimmer. For additional cord retention security, you may tie the
pig-tail and extension cord into a knot. See Figure 5 below.
Figure-3
Figure-4
6