Descargar Imprimir esta página

Whirlpool 7MWFC9822HC Manual De Uso Y Cuidado página 28

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.whirlpool.mx/owners
If you experience
Drying Operation
Drying cycle will not run
Unusual Noise
Rattling or vibrating noise
Loud humming
or increased noise
during cycle
Drying Results
Clothes are not drying
satisfactorily or drying
times are too long
Lint on load
Dried loads are wrinkled
Load too hot
28
All manuals and user guides at all-guides.com
for assistance and to possibly avoid a service call.
Possible Causes
Door not closed completely.
Start/Pause button not touched
firmly.
Drain pump filter not in place
or clogged.
Household fuse is blown or circuit
breaker has tripped.
Wrong type of fuse.
Water supply to washer/dryer
not connected and turned on.
Dry cycle not selected.
A small object caught between
the edges of drum.
Washer/dryer isn't properly leveled.
Clothing is balled up in washer/dryer.
Load is packed tightly.
The load is too large and heavy
to dry quickly.
Area under door seal is clogged with
lint.
Drain pump filter is clogged with lint.
The load was not removed from
washer/dryer at the end of the drying
cycle.
The washer/dryer was tightly packed. Dry smaller loads that can tumble freely. Loading drum half full
Load removed before cool-down
portion of cycle is complete.
Solution
Make sure the washer/dryer door is closed completely.
Touch the START/PAUSE button firmly.
Clean the drain pump filter. See "Cleaning the Drain Pump Filter/
Draining Residual Water." Place drain pump filter back in washer/
dryer and make sure it is properly seated.
There may be two household fuses or circuit breakers for the
washer/dryer. Check that both fuses are intact and tight, or that
both circuit breakers have not tripped. Replace the fuses or reset
the circuit breaker. If the problem continues, call an electrician.
Use a time-delay fuse.
Connect the water supply to the washer/dryer and turn it on.
The drying cycle will not run unless the water supply is
connected and turned on.
Select drying function (see Step 10 in "Using the All-In-One
Washer/Dryer").
Check the front and rear edges of the drum for small objects.
Clean out pockets before laundering.
The washer/dryer may vibrate if not properly installed. See
Installation Instructions. All four washer/dryer feet should be
in firm contact with the floor.
When balled up, the load will bounce, causing the washer/dryer
to vibrate. Separate the load items and restart the washer/dryer.
Loading drum half full or less will improve drying performance.
Separate the load to tumble freely. Loading drum half full or
less will improve drying performance and cycle time. Run a high
speed spin cycle.
Gently pull back the rubber door seal and clean lint with the
textured side of an affresh
®
Clean the drain pump filter. See "Cleaning the Drain Pump Filter/
Draining Residual Water." This procedure should be performed
occasionally.
Remove garments promptly at the end of the drying cycle,
or use the Wrinkle Shield option (see "Using the All-In-One
Washer/Dryer").
or less will improve drying performance and cycle time. Results
may also vary depending on fabric type.
Allow the drying cycle to complete the cool-down portion of the
cycle before removing the load. If you cancel the cycle before
the cool-down portion of the cycle and immediately remove the
load, it will be very hot.
Machine Cleaning Wipe.

Publicidad

loading