Publicidad
All manuals and user guides at all-guides.com
Energy Saving Tips
The appliance should be located in the coolest area of the room, away from heat producing
appliances or heating ducts, and out of the direct sunlight.
Let hot foods cool to room temperature before placing in the appliance.
appliance forces the compressor to run longer. Foods that freeze too slowly may lose quality, or
spoil.
Be sure to wrap foods properly, and wipe containers dry before placing them in the appliance.
This cuts down on frost build-up inside the appliance.
Appliance storage bin should not be lined with aluminum foil, wax paper, or paper toweling.
Liners interfere with cold air circulation, making the appliance less efficient.
Organize and label food to reduce door openings and extended searches. Remove as many
items as needed at one time, and close the door as soon as possible.
Try not to open the door too often, especially when the weather is wet and hot.
Every so often check if the appliance is sufficiently ventilated.
Ice and frost layer increase energy consumption, so clean the appliance as soon as the layer is
¼" thick.
You can solve many common appliance problems easily, saving you the cost of a possible service
call. Try the suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
Appliance does not operate.
Appliance does not cool.
Compressor turns on and off frequently.
The light does not work.
Vibrations.
The appliance seems to make too much noise.
The door will not close properly.
PROBLEMS WITH YOUR APPLIANCE?
TROUBLESHOOTING GUIDE
Not plugged in.
The circuit breaker tripped or blown fuse.
The appliance temperature control is set at "0"
Condenser coil at the back of the unit is dirty.
The room temperature is hotter than normal.
A large amount of food has been added to the
appliance.
The door is open too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The appliance does not have the correct
clearances. (5" to both sides and back of unit)
The home circuit breaker or fuse has tripped.
The appliance is unplugged.
The bulb has burned out (see the maintenance
section for the replacement procedure).
Check to assure that the appliance is level.
The rattling noise may come from the flow of the
refrigerant, which is normal.
As each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant in your
appliance.
Contraction and expansion of the inside walls
may cause popping and crackling noises.
The appliance is not level.
The appliance is not level.
The doors were reversed and not properly
installed.
The gasket is dirty.
The shelves, bins, or baskets are out of position.
11
Overloading the
POSSIBLE CAUSE
Publicidad
