Publicidad
Idiomas disponibles
Idiomas disponibles
YOUR vITAPUR® WATER DISPENSER
IMPORTANT NOTE: Your vitapur® water dispenser is designed with a special "safety" feature (float switch
mechanism) that controls activation/operation of the Kettle Feature hot water tank heating system. If no water is
present and/or low water levels are detected inside the internal water reservoir, activation/operation of the
Kettle Feature hot water heating system is not possible. Likewise, if the hot water heating system is operational
and water is being drawn simultaneously causing internal water levels to drop below the established minimal
level set point, hot water tank operation is automatically suspended. To reactivate the hot water heating system,
you must replenish your water supply.
NOTE: Operation of the cold water system is not affected by this safety feature.
1. Bottle support collar
2. Ready-To-Dispense indicator lights:
Blue:
"on"
"off"
Yellow:
"flashing"
"off"
3. Kettle Feature (on/off) activation button (self-illuminated)
"flashing" Heater (hot water tank) is operational.
"on"
The hot water has reached optimum temperature and is ready for dispensing.
"off"
Heater (hot water tank) is off, however remaining water within the tank may still be very hot, always
exercise caution when dispensing and/or draining water from the hot water tank.
4. Cold water dispensing button
5. Hot water dispensing button
6. Room temperature water push button
7. Removable drip tray
8. Refrigerated compartment with
adjustable shelf and LED light
9. Adjustable COLD water thermostat
(rear of dispenser)
9A. Adjustabe fridge thermostat
(rear of dispenser)
10. Drain valve (rear of dispenser)
11. Condenser coils (rear of dispenser)
All manuals and user guides at all-guides.com
The cold water has reached optimum temperature and is ready for dispensing
The cooling cycle is in progress, it is possible to dispense water during the cooling
cycle, however, optimum cooling temperature may not yet be achieved
Low water level inside internal reservoir. Hot water heating system cannot be activated.
(you must replenish water supply)
Internal reservoir water level is sufficient to activate hot water heating system
1
3
5
6
8
2
4
7
11
2
Min
9
9A
10
Publicidad
