Step 6 - Connect Vent System (Non-Vented Installation Only) - Haier HCH2100ACS Instrucciones De Instalación Y Manual Del Usuario

STEP 6 - CONNECT VENT SYSTEM
(NON‑VENTED INSTALLATION ONLY)
IMPORTANT: If the air deflector is not installed correctly, air will flow freely inside the
vent duct covers instead of being forced out of the vent openings on the side of the
vent duct cover.
1. Using the four screws (provided) in the Recirculation Kit, fasten the air deflector
to the duct cover bracket.
a
c
2. Measure from the bottom of the air deflector to the bottom of the hood exhaust
outlet.
b
d
e
3. Cut the duct to the measured size (X).
4. Remove the air deflector.
5. Slide the duct onto the bottom of the air deflector.
6. Place the assembled air deflector and duct over the exhaust outlet from the
hood.
7. Using the four screws removed in Step 4, reattach the air deflector to the duct
cover bracket.
8. Seal connections with vent clamps.
12
a
b
a
c
X
a
Air deflector
b
Vent clamp
c
X = length to cut vent duct
d
Vent duct
e
Exhaust outlet
a
Assembly Screws
b
Air Deflector
c
Duct Cover Bracket