Installation Requirements; Tools And Parts; Location Requirements - Haier HCH2100ACS Instrucciones De Instalación Y Manual Del Usuario

INSTALLATION REQUIREMENTS

TOOLS AND PARTS

Gather the required tools and parts before starting installation. Read and follow the
instructions provided with any tools listed here.
Tools needed
•
Level
•
Drill with 1¼", ¹⁄₈", and ⁵⁄₁₆" Drill Bits
•
Pencil
•
Wire Stripper or Utility Knife
•
Tape Measure or Ruler
•
Pliers
•
Caulking Gun
For non-vented (recirculating) installations, you will also need:
•
6" (15.2 cm) dia. round metal vent duct - length required is determined by ceiling
height.
Parts supplied
Remove parts from packages. Check that all parts are included.
•
120 V Power Cord (with 3 prong plug)
•
Hood Canopy Assembly (blower, vent
transition, light bulb and canopy glass
[pre-installed])
•
Metal Grease Filter
•
Vent Cover Support Bracket
(attached to vent cover)

LOCATION REQUIREMENTS

IMPORTANT: Observe all governing codes and ordinances.
Have a qualified technician install the range hood. It is the installer's responsibility to
comply with installation clearances specified on the model/serial rating plate. The
model/serial rating plate is located behind the left filter on the rear wall of the vent
hood.
Canopy hood location should be away from strong draft areas, such as windows,
doors and strong heating vents.
Grounded electrical outlet is required. See "Electrical Requirements" section.
•
Caulking Compound (weatherproof)
•
Vent Clamps
•
Jigsaw or Keyhole Saw
•
Flat-blade Screwdriver
•
Metal Snips
•
Phillips Screwdriver
•
Metric Hex Key Set
•
Two-Piece Vent Cover
•
4 x 8 Screws (4)
•
5 x 45 mm Mounting Screws (6)
•
8 x 40 Wall Anchors (2)
•
10 x 50 mm Wall Anchors (4)
5