Descargar Imprimir esta página

Garland SHAKER 310 DPG Manual De Instrucciones página 35

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
Avoid operating the equipment in wet grass, where
feasible. Take special care when using this machine
in the rain or after rain because the ground is slippery
and you can slip.
If you slip or fall stop accelerating and move the
switch to "O" (Off).
Do not rely solely on the warning signs on the
machine. Be always alert.
It is neccesary to pay attention to posible loosening or
overheating of parts of the machine. If you detect any
anomalies stop inmediatly the machine and check it
carefully. In case of failure take the machine to
the repair service. In any case you should continue
working if you feel that the performance is not correct.
Remember to always use the machine with clean
hands and without petrol and oil.
Do not allow any other person into the work area.
All other people must be at least at a distance of 15
metres as it is a dangerous area.
Never leave this machine unattended.
It is imperative that the engine is turned off when
carrying the machine from one working area to another.
Never touch elements that can be hot during
the start up or operating the machine, for
example, the escape, sparks or high voltage
cables.
Do not use accessories except those recommended
by our company as otherwise the use of other non
original accessories could cause severe damages to
the end user, to passers-by and to the machine.
Always follow the safety rules stated in this manual.
7.1. FIXING THE MACHINE AND GUIDANCE
Hold the machine with the harness, hands on the
handles and with the right hand in such a position that
you can action the controls (accelerator and security
switch).
Attention! So as to reduce the risk of loss of control
and possible damages (that could even be fatal) to the
end user and/or those surrounding him, never use this
machine single handedly.
8. MAINTENANCE AND SERVICE
Make periodic inspections of the machine to ensure
that the machine is correct. For a thorough inspection
take the machine to your dealer.
Before performing any maintenance or repair the
machine make sure the engine is off and remove
the spark plug cap. Perform all maintenance of the
machine when is set on a flat and clear surface.
Never try adjustments in the machine if it is running
and / or attache to the user by the harness. Perform
all maintenance of the machine when is set on a flat
and clear surface.
Use only suitable spares to get a proper performance
for this machine. This replacement can be found on
the official distributor of the machine. Using other
sparks may causes risks, damage to the user or
people around the machine.
Carburetor adjustment is complicated and should
be done only by the service.Carburetor regulation
is complicated and should only be carried out by a
service agent. An incorrect regulation of the carburetor
can cause damages to the engine and is sufficient
motive to cancel the warranty.
35/124
English

Publicidad

loading