UNPACKING AND STACKING
1. After removing the carton and shipping material,
lift the washer off the foam base. Make sure the
plastic tub support comes off with the base and
is not stuck to the bottom of the washer.
Plastic Tub
Support
If you must lay the washer down to remove the base
packaging materials, always protect the side of the
washer and lay it carefully on its side. DO NOT lay
the washer on its front or back.
2. Save the foam block for future use. If the washer
must be moved in the future, the foam block
will help prevent damage to the washer during
transportation.
NOTE: To prevent damage, do not remove
the foam block until the washer is at the final
location.
3. Turn the top cover about 180 degrees. Cover the
upper hole with the top cover and install 4 short
screws (included in packing box) to fix it in place.
Short screws
WARNING
y The top cover must be installed to avoid the risk of
electric shock or short circuit. Failure to do so can
cause serious injury, fire, electric shock or death.
MFL68267005_E.indd 9
4. Make sure the leveling legs on the front-loading
washer are fully retracted before stacking it
on top of the pedestal washer. Position the
appliance on top of the pedestal washer.
5. Make sure the holes on the pedestal washer
align with the holes in the front-loading washer,
Carton Base
then install 4 long screws (included in box) at
each corner to securely attach the front-loading
washer to the pedestal washer.
6. Extend the legs of the front-loading washer
slightly until it is snugged up against the pedestal
washer. Extend all the legs ½ turn with wrench
and tighten all 4 locknuts.
TOOLS YOU WILL NEED
y Adjustable Pliers
Top cover
y Screwdriver
NOTE: For instructions on stacking under a top-load-
matching dryer, see the instructions in the dryer stacking kit
which is available on LG.com.
INSTALLATION INSTRUCTIONS
Long screws
1
2
Locknut
• Carpenter's Level
Scan the QR code to link
directly to an install video
tutorial.
9
Washer legs
2018. 7. 18. 오전 9:22