Fanaway Classic Manual De Instrucciones página 4

Fanaway Classic Installation Instructions
1 Mounting bracket x 1
2 Canopy x 1
3 Down rod with ball joint x 1
4 Bolt and pin cover x 1
5 Bolt x 1
6 Pin x 1
7 Fan assembly x 1
8 Screw for lamp base x 3
9 Lamp shade x 1
10 Light kit x 1
If there isn't an existing outlet box, then install one using the following instructions:
•
Disconnect the power by removing the fuses or turning off the circuit breakers.
•
Secure the outlet box (A) (not included) directly to the building structure. Use appropriate fasteners
and materials (not included). The outlet box and its bracing must be able to fully support the weight
of the moving fan (at least 35 lbs). Do not use a plastic outlet box.
•
Figures below show three different ways to mount the outlet box (A) (not included).
Fig. 2
This fan hanging system supports a maximum 20 degree angled ceiling installation. Fig. 4
NOTE: If you are installing the ceiling fan on a sloped ceiling, you may need a longer downrod to maintain
proper clearance between the tip of the blade and the ceiling.
NOTE: The ceiling fan must be installed in a location so that the blades are spaced 300mm from the tip
of the blade to the nearest objects or walls.
NOTE: For angled ceiling installation, the opening of the mounting bracket (B) must be pointed toward
the peak.
4 | P a g e
All manuals and user guides at all-guides.com
INSTALLING THE MOUNTING BRACKET
Fig. 3
11 Bulb x 3
•
12 Wood screw x 2
•
Machine screw x 2
•
Flat washer x 2
•
Spring washer x 2
13 Wire nut x 6
14 Balance tape x 4
15 Receiver x 1
16 Remote x 1 set
Angled ceiling
Maximum 20°
L D - 0 0 0 3 - 1 6 / X X X / 0 1
Fig. 4