Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
outdoor area. Carbon monoxide exhaust
fumes can be lethal in a confined area.
WARNING:
chain properly installed.
STARTING INSTRUCTIONS
1. Mix gas with oil. Fill fuel tank (Fig. 3) with fuel/oil
mixture. See Oil and Fuel Mixing Instructions.
2. Fill the oil tank (B) with correct chain and bar oil (Fig. 3).
3. Be certain the Chain Brake® is disengaged (C) before
starting unit (Fig. 3).
4. Slide the slider STOP switch down (Fig. 4). The Blue
Lever (H) has 3 positions: Positions 1, 2 and 3 (Fig. 6).
5. Fully press and release the primer bulb (G) 10 times,
slowly. Some amount of fuel should be visible in the
primer bulb (Fig. 5). If you can't see fuel in the bulb,
press and release the bulb as many times as it takes
before you can see fuel in it.
6. Move the lever (H) to Position 1 (Fig. 6).
NOTE: This unit will not run with the lever in Position 1.
7. Place the saw on a firm flat surface. Hold saw firmly
as shown (Fig. 7).
8. Hold down safety trigger (E) and squeeze the throttle
trigger (D). With thumb, press down on the throttle
latch (F). This will lock the throttle into wide open
position (Fig. 3). Pull the rope with a controlled and
steady motion 4 times.
NOTE: The unit uses Spring Assist Starting™, which
significantly reduces the effort required to start the
engine. You must pull the starter rope out far
enough to hear the engine attempt to start. There
is no need to pull the rope briskly-- there is no
harsh resistance when pulling. Be aware that this
starting method is vastly different from (and much
easier than) what you may be used to.
9. Then move the lever (H) to Position 2, being sure to
keep the throttle control locked. Hold saw firmly and
pull rope until saw starts. This could take 4 more pulls.
10. Let the saw warm up for 10 seconds. Depress and
release trigger (F) for idle.
11. Move lever (H) to Position 3. If engine fails to start,
repeat these instructions.
10
All manuals and user guides at all-guides.com
STARTING/STOPPING INSTRUCTIONS
Operate this unit only
in a well- ventilated
Never operate the saw
without the bar and
C
B
Fig. 3
Slider Stop Switch
Fig. 4
Fig. 5
Fig. 6
Fig. 7
F
E
D
A
G
H
Publicidad
