Beper BP.603H Manual De Instrucciones página 9

EN
Blender Use instructions
DESCRIPTION Fig.A
A. Cap
B. Jar lid
C. Graduated jar
D. Blades
E. Motor unit
F. Switch and speed selection knob (PULSE 0,1,2)
INSTRUCTION FOR USE
Make sure the appliance is unplugged and that the switch and speed selection knob is on "0" position.
Put the graduated jar on the motor unit in the correct way and turn it clockwise until it is blocked.
Cut fruits and vegetables in pieces and put into the jar with water or milk. Do not exceed the maximum capacity
of the jar.
Put the lid complete of cap on the jar and press lightly, making sure that the spout of the container is covered by
the tab of the lid.
Plug in the appliance.
Switch on the appliance by turning the switch and speed selection knob in position "Pulse", if you want to activate
"Pulse" function, on position "1" for low speed and on position "2" for high speed.
When finished and desired consistence obtained, switch off the appliance by turning the switch and speed se-
lection knob in position "0" and unplug it.
CLEANING
It is recommended to clean the appliance immediately after use, as follows :
Unplug the appliance.
Remove the jar from the motor unit by turning slightly anticlockwise.
Remove the lid by turning slightly in order to be able to hold the tab.
Remove the blades by turning anticlockwise the base of the jar.
The jar, the lid, the cap and the blades can be washed into water.
Do not use detergents or abrasive cloth that could damage the appliance.
The motor unit, and the power cord must be cleaned only with a slightly damp cloth.
Make sure that the appliance will be dry before next use and/or before store it.
TECHNICAL DATA
Power: 300-350W
Power supply: 220-240V ~ 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
9