Publicidad
Idiomas disponibles
Idiomas disponibles
5. When weights have been tared out, the display will show a negative
number when the items are removed from the scale. To reset the
scale back to zero for a new measurement, press the "ON/TARE"
button. The scale resets to zero.
Precautions
1. Clean exposed parts with a soft, slightly damp cloth. To remove stains,
use a mild soap. Never use detergents, excess water, treated cloths,
harsh cleaning agents, or sprays.
2. Do not tamper with the scale's internal components. Doing so will
invalidate the warranty on this unit and may cause damage. The
scale contains no user-serviceable parts.
3. Although your scale is designed to be maintenance-free, it contains
sensitive electronic parts. Avoid rough treatment. Treat it with care to
ensure the best performance.
4. This scale is intended for home/consumer use only. It is not intended for
commercial or medical use.
5. This scale is designed to read weights up to 11 lbs/5 kgs. To prevent
damage, do not place more than 11 lbs/5 kgs on it.
6. Do not store scale where you store cleaning chemicals. The
vapors from some household products may affect the electronic
components of your scale. Do not store scale on its side.
7. This scale is an extremely sensitive weighing device. In order to prevent
run down of the battery, do not store anything on the scale.
8. Do not dispose of batteries in fire. Batteries may explode or leak.
Remove the battery if the scale will not be used for a long period of
time.
9. Overload Warning: Should "O-Ld" appear on the display during a
weighing, this indicates that the maximum weighing capacity of
the scale has been exceeded. Remove the weight immediately;
otherwise, permanent damage could occur.
Caution: Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
Note: This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation. This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
3
Publicidad
