Choice And Installation Of Sanding Pads; Attaching The Abrasive - Festool ROTEX RO 150 FEQ Manual De Instrucciones

Eccentric motion (fi ne sanding)
This motion is recommended for sand-
ing with low material removal for a
scratch-free fi nish (fi ne sanding).
Press the switch (6.1) downwards and push
it into the left-hand position.
Choice and installa-
tion of sanding pads
The tool can be fi tted with three sanding pads
of different hardnesses depending on the sur-
face to be sanded.
Hard: Coarse sanding on surfaces, sanding
at edges.
Soft: Universal use for coarse and fi ne sand-
ing for fl at and curved surfaces.
Super-soft: Fine sanding on formed parts,
curves, radii. Do not use on edges!
Installation
The FastFix system enables tool-free replace-
7.1
ment of the sanding pad (7.4):
- Set the switch (7.1) to the right, to the Rotex
rotary motion
7.2
- Press spindle stop (7.2),
- Turn the fi tted sanding pad from the spindle
7.3
(right-handed thread)
- Keep the spindle stop pressed and screw
7.4
on the new sanding pad (in doing so, make
sure that the rubber collar (7.3) is correctly
fi tted!).
- Let go of the spindle stop.
Actuate the spindle stop only when
the drive spindle is stationary. Do not switch
on the motor when the spindle stop is pressed
in.

Attaching the abrasive

Stickfi x is a hook-and-loop fastening
system. Stickfi x sanding pads allow
the use of self-adhesive hook-and-loop
abrasives such as Stickfi x sandpapers
and sanding cloths.
Simply press the abrasive onto the sanding
pad and pull it off again after use.
8