Hkoenig PLX820 Manual De Instrucciones página 9

STEP 4
INSTRUCTIONS FOR USE
Follow these instructions carefully to avoid seriously damaging your plancha and causing injury to
yourself and to property.
1. Assemble the plancha by following the assembly instructions carefully.
2. Connect the gas hose to the plancha. Connect the regulator to the hose.
3. Connect the regulator to the cylinder valve following the regulator instructions supplied with the
regulator.
4. Turn all of the control knobs to the 'OFF' position before turning on the gas supply to the appliance.
5. Operate the regulator in accordance with the instructions supplied with the regulator.
LIGHTING YOUR PLANCHA
Lighting Instructions:
1. Connect the gas cylinder to the plancha following the instructions supplied with the regulator.
2. Turn all the control knobs to the 'OFF' position.
3. Turn 'ON' the gas supply at the cylinder or regulator switch following the regulator connection
and operating instructions. Check the cylinder to regulator connection and hose to plancha hose
inlet connection for leakage using soapy water. Any leakage will show as bubbles in the area of
the leak. If leak is found, do not use the plancha. Consult your gas or plancha supplier for
advice.
4. To light the left hand burner, push down and turn the left burner control knob anti-clockwise to
the 90° position (full rate position). An audible click will be heard, this should light the burner.
Check that the burner is alight. If the burner has not lit, repeat this process.
5. If the burner has not lit after two attempts, turn 'OFF' the gas tap and wait 5 minutes before
retrying the ignition sequence.
6. When the burner has lit, the burner rate can be adjusted by push down and turn the knob anti-
clockwise to any position between the full and low rate position.
7. Light the remaining burners from left to right in sequence.
8. To turn 'OFF' the plancha, turn the cylinder valve handle or regulator switch to the 'OFF' position
by following the regulator instructions. Once the burners have extinguished turn all the control
knobs to the 'OFF' position.
All manuals and user guides at all-guides.com