Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION:
Before
starting
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box.
Turning power off using the fan switch is not
sufficient to prevent electric shock.
Step 1. Remove 1 of 3 screws from the posts of
the mounting plate and keep it for future use.
Loosen the other 2 screws. (Do not remove)
Step 2. While holding the light kit under your
fan, make the polarized plug connections: (Fig.
14)
- White to white
- Blue to black
Step 3. Place the key holes in the light kit over
the two screws previously loosened from the
mounting plate. Turn the light kit until the light
kit locks in place at the narrow section of the key
holes. (Fig. 14)
Step 4. Securely tighten the two mounting
screws previously loosened and the one
previously removed.
Step 5. Raise glass shade up against the light kit
and secure it to fan by turning glass clockwise
until snug. DO NOT OVERTIGHTEN. (Fig. 15)
Step 6. Install 1 x 7W LED bulbs (included).
Installing the Light Kit and Glass Shade 8.
installation,
Wire connectors
Light kit
Figure 14
Bulbs
Mounting Plate
Screws
Figure 15
Light kit
Glass
shade
Publicidad
