Progress Lighting AirPro P250075 Manual De Instalación página 7

Hanging the Fan
REMEMBER
to turn off the power. Follow the
steps below to hang your fan properly:
Step 1. Remove the decorative canopy bottom
cover from the canopy by turning the cover counter
clockwise.(Fig. 5)
Step 2. Remove the mounting bracket from the
canopy by removing the 1 of 2 screws from the
bottom of the mounting bracket and loosening the
other one a half turn from the screw head. Next,
turn the canopy counter clockwise to removing the
mounting bracket from the canopy. (Fig. 5)
Step 3. Pass the 120-volt supply wires through the
center hole in the ceiling hanger bracket as shown
in Fig. 6.
Step 4. Secure the hanger bracket to the ceiling
outlet box with the screws and washers provided
with your outlet box.
Step 5. Remove the hanger pin, lock pin and set
screws from the top of the motor assembly. (Fig. 7)
Step 6. Route the wires exiting from the top of the
fan motor through the coupling cover, canopy cover
and canopy and then through the ball / downrod.
(Fig. 7)
Step 7. Align the holes at the bottom of the
downrod with the holes in the collar on top of the
motor housing (Fig. 7). Carefully insert the hanger
pin through the holes in the collar and downrod.
Be careful not to jam the pin against the wiring inside the
downrod. Insert the locking pin through the hole near the
end of the hanger pin until it snaps into its locked position,
as noted in the circle inset of Fig. 7.
WARNING
FAILURE TO PROPERLY INSTALL
LOCKING PIN AS NOTED IN STEP 7
COULD RESULT IN FAN LOOSENING AND
POSSIBLY FALLING.
Step 8.
Tighten two set screws on top of the fan motor
firmly. (Fig. 7)
Step 9.
Place the downrod ball into the hanger bracket
socket.
Ceiling hanger
bracket
Figure 5
Ceiling
hanger
bracket
120V Wires
Figure 6
Supply wires
Downrod
Canopy
Canopy cover
Coupling cover
Ceiling
canopy
Hanger pin
Canopy
cover
Figure 7
UL Listed
electrical
box
Washers
Mounting screws
(supplied with
electrical box)
Pin in locked
position
Set screws
Lock pin
4.