Publicidad
Idiomas disponibles
Idiomas disponibles
Sliding tube (33) into tube (131) will
reduce the length of focus bar swing
and pulling the tube (131) out will
increase the length of the swing Fig.8.
9.- FITTING THE FOCUS BAR
SIDE COVERS.-
Take the covers (15R), marked on the
inside with the letter "R", and position
them at the spindle end with the bars
on the right hand side, as shown in
Fig.10B. Now use screws and (27) to
attach them.
Carry out the same procedure at the
other end of the bar using the covers
(15L) marked on the inside with the
letter "L".
10.- FITTING THE CENTRAL
COVERS.-
Take the front (23H) and rear (23Q)
covers and position them on the main
post (25), Fig.10A. Now use the screws
(24) and (27) to attach them to the
post.
11. FITTING THE FOOTRESTS.-
Position the right footrest (35R marked
with the letter "R") on top of the unit's
right foot (42R), Fig.11, (left and right
refers to the user's position doing
exercise) .
Refit the screws (44), the washers
(43) and the spring washers (32), and
tighten securely.
Next, position the left footrest (35L
marked with the letter "L") on top of
the left foot (42L), refit the screws
(44), the washers (43) and the spring
washers (32), and tighten securely.
12. FITTING THE HANDLEBAR.-
Bring the handlebar (10) up to the
handlebar stem (25), Fig.12. Fit the
handlebar bracket (9), insert screw
(12) and hand tighten, put the washer
(11), position the handlebar and
tighten gently, then fit the bracket
cover (13).
13. FITTING MONITOR.-
ATTACHING THE FEEDBACK
CABLE.
Take hold of the cable (116), which is
sticking up out of the main post (25),
Fig.13, and plug it into the connector
of the electronic unit (114), as shown
in Fig.13.
FITTING THE HAND-GRIP CABLE.
Take hold of the Hand-grip connectors
(117), sticking out of the main post
(25),
and
connectors located at the back of the
monitor (114), as shown in Fig.13.
ATTACHING THE MONITOR.-
Next, slide the front of the monitor
(114) onto the plate on top of the main
post (25) in the direction of the arrow,
Fig.13, push the cables down into the
main post making sure not the pinch
any of the cables. Replace the screws
(103).
ATTENTION:
It is important to retighten all of the
screws involved in assembling the
machine after approximately a week of
use as this will prevent any strange
noises and possible damage.
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits fl
at on the fl oor and that it is level. This
can be achieved by screwing the
adjustable feet (72) up or down, as
shown in Fig.14.
17
plug
them
into
the
Publicidad
