Schulz AIR Plus Spray Split Manual De Instrucciones página 38

POSSIBLE ADJUSTMENTS OF THE SPRAYING IMAGE
Figure 8a = vertical fl at jet For horizontal surfaces
Figure 8b = horizontal fl at jet For vertical surfaces
For corners and edges, as well as for areas hard
Figure 8c = circular Jet
to reach
TABLE 9.3 - ADJUSTMENTS OF THE SPRAYING IMAGE
Note: It is advisable to test the spraying on a white sheet of paper, to determine the position and the correct
amount of the material to be applied.
2. CONTROL OF THE AMOUNT OF THE MATERIAL
2.1 AIR PLUS SPRAY SCHULZ - Split
Defi ne the amount of the material, turning the regulator of the air intake of the gun (see Figure 9.7):
+ turning to the right greater volume of material
- turning to the left smaller volume of material
2.2 AIR PLUS SPRAY SCHULZ Compact
Defi ne the amount of the material, turning the regulator with the activation trigger of the gun (see Figure 9.6):
+ turning to the right greater volume of material
- turning to the left smaller volume of material
-
+
-
+
FIGURE 9.6 FIGURE 9.7
3. SPRAYING TECHNIQUES
The result of the work depends directly on the fi nishing and cleaning degree of the surface to be painted. Prepare
the region carefully leaving it free of dust or dirt;
Protect the surfaces that will not be painted;
Perform uniform motion, by doing it you will get better quality fi nishing;
Clean with solvent or with water the fi nishing material waste that eventually accumulates in the spraying nozzle
or the paint regulator;
The spraying motion must start from the arm and not form the hand joint. With this, you will guarantee the dis-
tance between the equipment and the working area, keeping it constant. Depending on the width of the spraying
jet, keep a distance from 5 to 15 cm;
The Figure 9.8A – CORRECT – shows the correct distance with a quality and homogeneous fi nishing.
The Figure 9.8B – WRONG – shows an uneven distance, a surface with a lower and not homogeneous fi nishing.
38