RIDGID R86042 Manual Del Operador página 6

SYMBOLS
The following signal words and meanings are intended to explain the levels of risk associated with this product.
SYMBOL SIGNAL
DANGER:
WARNING:
CAUTION:
NOTICE:
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper inter-
pretation of these symbols will allow you to operate the product better and safer.
SYMBOL
V
min
n
.../min
FEATURES
PRODUCT SPECIFICATIONS
Grinding Wheel Capacity ........................................4-1/2 in.
Recommended Grinding Wheel
Thickness .................................................... Type 27, 6 mm
MEANING
Indicates a hazardous situation, which, if not avoided, will result in death or
serious injury.
Indicates a hazardous situation, which, if not avoided, could result in death or
serious injury.
Indicates a hazardous situation, that, if not avoided, may result in minor or
moderate injury.
(Without Safety Alert Symbol) Indicates information considered important, but
not related to a potential injury (e.g. messages relating to property damage).
NAME
Safety Alert
Read Operator's
Manual
Eye Protection
Eye and Hearing
Protection
Wet Conditions Alert
Recycle Symbol
Volts
Minutes
Direct Current
Rated Speed
Per Minute
DESIGNATION/EXPLANATION
Indicates a potential personal injury hazard.
To reduce the risk of injury, user must read and understand operator's
manual before using this product.
Always wear eye protection with side shields marked to comply with
ANSI Z87.1.
Always wear eye protection with side shields marked to comply
with ANSI Z87.1 as well as hearing protection when operating this
equipment.
Do not expose to rain or use in damp locations.
This product uses lithium-ion (Li-ion) batteries. Local, state or federal
laws may prohibit disposal of batteries in ordinary trash. Consult your
local waste authority for information regarding available recycling and/
or disposal options.
Voltage
Time
Type or a characteristic of current
Maximum rotational speed
Revolutions, strokes, surface speed, orbits etc., per minute
Rated Speed ..................................................... 10,600/min
Spindle Thread ......................................... 5/8 in. x 11 UNC
6 - English