Publicidad
Idiomas disponibles
Idiomas disponibles
BULB REPLACEMENT
IMPORTANT
● The bulb must be replaced by the manufacturer, its service agent or similarly qualified persons.
● Always switch off the electricity supply before carrying out any operations on the appliance. When
handling bulb, make sure it is completely cool down before any direct contact to hands.
● When handling globes hold with a cloth or gloves to ensure perspiration does not come in contact
with the globe as this can reduce the life of the globe.
Changing the light
● Loosen the 2pcs ST4*8mm self-tapping screw from the lighting panel, take out the lighting fixture.
● Disassembly the 3pcs ST3*12mm screws on the terminal box cover and take down the wire cover.
● Pull out the terminal from the PCB terminal block, disconnect the wire connector and replace the lamp.
Note: It must be sure that the power supply is completely cut off before the above operation.
● ILCOS D code for this lamp is: DBS-2/65-H-120/33
» LED modules –rectangle lamp
» Max wattage: 1×2 W
» Voltage range: AC 110-240V
» Dimensions:
INFORMATION FOR DISMANTLING
Do not dismantle the appliance in a way which is not shown in the user manual. The appliance could not
be dismantled by user. At the end of life, the appliance should not be disposed of with household waste.
Check with you Local Authority or retainer for recycling advice.
120 mm
[ EN ● 14 ]
Version: 3:0
KEN002DH 24.02.2021
Publicidad
