SUHNER ABRASIVE LLC 23-TOP Documentación Técnica página 12

1. n
1.1 g
enerAl notes on sAfety
This operation manual is applicable for the machine LLC
23-TOP.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The tool is designed for grinding, milling, and deburring
metal, stone, and plastic with burrs and abrasives. The
machine is designed exclusively for 2-hand use.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Otto Suhner AG, Industriestrasse 10, CH-5242 Lupfig,
hereby declares under sole responsibility that the product
with the serial or batch no. (see reverse side) complies
with the requirements under the Directive 2006/42/EG.
Applied standards: EN ISO 12100, EN ISO 11148. Docu-
ment Agent: M. Voyame. CH-Lupfig, 12/2017
M. Voyame/Division manager
2. c
2.1 P
rior to tAKing the mAchine into serVice
Oiled compressed air is recommended (see also
air quality under section 2.3).
Observe national regulations.
2.2 t
AKing the mAchine into serVice
2.2.1 t /t
urn on urn off
Tilt lock forward and press lever on plastic sleeve. Releas-
ing the lever switches the machine OFF.
12
S
oteS on afety
ommISSIonIng
2.3 r
Ating dAtA
Pressure
Power output
Air consumption full load
Air consumption at idling
Setting oiler idle
No-load speed
Sound pressure level EN ISO 15744 82dB(A), K=3dB(A)
Sound power level EN ISO 15744
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight
2.4 o
PerAting conditions
Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3. h
andlIng
3.1 t
ools
Use only clean tools!
3.1.1 c /
hAnging fitting the tool
Hold spindle by wrench flats with open end wrench and
release/tighten down collet chuck with open end wrench.
Perform a trial run a minimum over a period of 30 seconds
without load.
3.2 w
orKing instructions
On failure of the compressed air release the valve lever!
To achieve an optimum grinding result, move grinding
wheel uniformly back and forth with light pressure. Exces-
sive pressure lessens the working capability of the ma-
chine, as well as the life of the grinding wheel.
max. 6.3bar
330W
3
0.65m /min
3
0.79m /min
3-4 drops/min
-1
24'000min
93dB(A), K=3dB(A)
2 2
2.7m/s , K=1.0m/s
3/4/4
0.810kg
/o
peratIon