Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: Move the entire package to the selected site. Do not drag the spa tub across the ground as this can cause damage and leakage. Open the carton
carefully as this can be used to store the spa over long periods or when not in use.
NOTE: Lay out all the parts on the ground and make sure they are all accounted for. For missing or damaged parts contact the appropriate MSpa
after-sales service center.
SPA SETUP: MONO / NAVAL
ASSEMBLY - MONO / NAVAL
Spa Control Unit Assembly
1. Take out the foam mat and spread it over the cleared area. Then spread out the spa tub over the ground mat and point the connection tubes towards the
corner where you intend to set up your external control box.
2. Ensure all the rubber sealing rings are in place.
3. Connect the control box to the spa by lining up the numbers (1 to 1, 2 to 2 and 3 to 3). Securely hand-tighten the connectors.
NOTE: Do not use tools to tighten.
1.
Inflating the Spa Tub Wall
1. Attach the pump hose to the hand pump and tighten it securely.
2. Open the valve cap by twisting it counter-clockwise. Ensure the valve is clear from debris, sand, or dirt before releasing.
3. Push the valve button in and turn it counter-clockwise 90 degrees so it pops up and is in the "OUT" position.
4. Connect the pump nozzle to the valve receptacle on the spa body, and tighten it clockwise.
5. Start pumping air into the SPA tub by sliding the pump piston up and down, inflate the spa to 12 PSI (only the spa tub, not the bladder).
NOTE: Gauge will not respond until reaching 4psi. Just keep pumping for 2-3 minutes!
6. Attach the U-shape cover to the spa control box.
NOTE: The U-shape cover must be installed before using the spa. CAUTION: Do not sit on, lean on, cover or place any objects over the spa control unit.
1.
5.
2.
2.
3.
3.
①
6.
10
3
3
2
2
1
1
4.
①
Publicidad
