mspa F-NA062W Naval Manual De Instrucciones página 18

Spa Tub and Air Bladder Repair
Use the enclosed repair patch to repair any puncture:
1. Clean and dry the area to be repaired thoroughly
2. Apply the glue to the PVC patch and quickly attach it onto the damaged surface. (Glue is not included)
3. Smooth the surface to remove any air bubbles and allow it to dry for 5-10 minutes
NOTE: Glue is not included.
1
How to fix a leaking valve (MONO / NAVAL)
A. Try to tighten the valve
B. Re-install or replace the valve
1. Completely deflate your spa
2. Remove the dust cap, insert the valve wrench into the valve and turn counter-clockwise to remove the valve
Rubber Ring
3. Check the rubber ring to make sure that it is in the correct position, secured tightly around the valve, and check that there is no debris in the way
4. Ensure that the pin spring is functioning properly and that there are no cracks along the edges
Water Outlet & Inlet Cap And Air Inlet Cap Instructions
For Spa models with external control box, the following caps are offered in the repair kit:
1. Air inlet cap x 1pc
2
pin hole pin hole
1. Inflate your spa to the max air pressure
2. Insert your valve wrench into the valve and turn the wrench clockwise to tighten the valve onto the spa
2. Water outlet & inlet cap x 2pcs
18
3
pic 1