Publicidad
Idiomas disponibles
Idiomas disponibles
2. Press and hold ID SET on the rear of the subwoofer for at least 5 seconds.
• The red indicator on the rear of the subwoofer turns off and the blue indicator blinks.
3. Press the Up button on the remote control for 5 seconds.
• The ID SET message appears on the display of the Soundbar for a moment, and then it disappears.
• The Soundbar will automatically power on when ID SET is complete.
4. Check if the LINK LED is solid blue (connection complete).
LED Indicator Lights on the Rear of Subwoofer
LED
Blue
Red
Red and blue
NOTE
• If the main unit is powered off, the wireless subwoofer will go into stand-by mode and the STANDBY LED on the rear of the sub-woofer will
turn red after blinking in blue several times.
• If you use a device that uses the same frequency as the Soundbar near the Soundbar, interference may cause some sound interruption.
5 Sec
Rear of Subwoofer
5 Sec
The LINK LED indicator stops blinking and glows a solid blue when a connection
is established between the Soundbar and the Wireless Subwoofer.
Blue is On
Status
Successfully connected
On
(normal operation)
Blinking
Recovering the connection
Standby (with the
Soundbar main unit turned
off)
On
Connection failed
Blinking
Malfunction
Rear of Subwoofer
Description
-
Check if the power cable attached to the main Soundbar
unit is connected properly or wait about 5 minutes.
If blinking persists, try manually connecting the
subwoofer. See page 12.
Check if the power cable attached to the main Soundbar
unit is connected properly.
Connect again. See the instructions for manual
connection on page 12.
See the contact information for the Samsung Service
Center in this manual.
ENG - 13
Blinking
blue fast
ID SET
Resolution
Publicidad
