Alecto DBX-37 Manual De Instrucciones página 14

Use switch
To save batterypower, the nightlight can only be switched-on when the transmit-
ter is powered by the power adapter.
Use a soft moistened cloth to clean the set.
Avoid placing the receiver and the transmitter in direct sunlight or wet locations.
Do not let water and sand enter the units.
In case the transmitted signal is disturbed or interrupted, check the functionality
at another location first, prior to send it in for repair.
Always remove the batteries in case the unit is not in use for a longer period.
Should any problem occur, please check the list below.
bad or no reception:
battery is weak or empty, replace battery
channel switch is set wrong, change channel
transmitter-receiver distance too large, reduce distance
adapter connection wrong, check adapter connection
noise and other sounds:
other transmitter present, change channels
disturbance by other devices, switch off other devices (when possible)
shrill tone:
transmitter too close to the receiver, increase distance
volume of receiver is set too high, reduce volume
no nightlight:
the unit is powered by battery (the nightlight can only be used when the
transmitter is powered by the power adapter)
to switch ON/OFF the nightlight.
TROUBLESHOOTING
NIGHTLIGHT
MAINTENANCE
14