DeWalt DCLE34030G-QU Manual Del Usuario página 14

Battery Safety
E
WARNING:
Batteries can explode, or leak, and can
cause injury or fire. To reduce this risk:
• Carefully follow all instructions and warnings on the
battery label and package, and the accompanying
Battery Safety manual.
• Do not dispose of batteries in fire.
• Keep batteries out of reach of children.
• Remove batteries when the device is not in use.
• Use only the charger specified for your rechargeable
battery pack.
• Disconnect the battery pack from the laser before
making any adjustments, changing accessories, or
storing the laser. Such preventative safety measures
reduce the risk of starting the laser accidentally.
• Use the laser only with specifically designated
battery packs. Use of other battery packs may create
a risk of injury and fire.
• Under abusive conditions, liquid may be ejected from
the battery; avoid contact. If contact accidentally
occurs, flush with water. If liquid contacts eyes,
additionally seek medical help. Liquid ejected from
the battery may cause irritation or burns.
• Do not use a battery pack or laser that is damaged or
modified. Damaged or modified batteries may exhibit
unpredictable behavior resulting in fire, explosion, or
risk of injury.
• Do not expose a battery pack or laser to fire
or excessive temperature. Exposure to fire or
temperature above 265° F (130° C) may cause an
explosion.
• Follow all the charging instructions and do not charge
the battery pack outside of the temperature range
specified in the instructions. Charging improperly or
at temperatures outside of the specified range may
damage the battery and increase the risk of fire.
14
• Do not store or use the tool and battery pack in
locations where the temperature may fall below
39.2 ˚F (4 ˚C) (such as outside sheds or metal
buildings in winter), or reach or exceed 104 ˚F
(40 ˚C) (such as outside sheds or metal buildings
in summer).
Powering the Laser
This laser can be powered by either of these battery
packs:
• A D WALT 12V MAX* Li-ion Battery Pack.
e
*Maximum initial battery voltage (measured without a
workload) is 12 volts. Nominal voltage is 10.8.
• A D WALT 20V MAX* Li-ion Battery Pack.
e
*Maximum initial battery voltage (measured without a
workload) is 20 volts. Nominal voltage is 18.
Battery Type
DCB120, DCB121, DCB122,
12V DCB123, DCB124, DCB125,
DCB126, DCB127
DCB201, DCB203, DCB203BT,
DCB204, DCB204BT, DCB205,
20V
DCB205BT, DCB206, DCB207,
DCB208, DCB230, DCB240
Use of any other batteries may create a risk of fire.
Charging the Li-ion Battery
If the DEWALT 12V/20V MAX* Li-ion battery pack is
1.
attached to the laser, remove it.
• While pressing down on the release button on the
battery pack (Figure
B 1
up to unlock it from the laser.
• Pull the battery pack the rest of the way up and
out of the laser (Figure
Plug the charger cord into an electrical outlet.
2.
Slide the battery pack into the charger until it snaps
3.
in place (Figure ). On the charger, the left
A 1
Battery Pack
), pull the battery pack
).
B 2