Getting Started; Initial Setup; Basic Operation - DeWalt DCT411 Manual De Instrucciones

To remove the battery pack from the tool, press the release button
(Y) and firmly pull the battery pack out of the tool handle. Insert it
into the charger as described in the charger section of this manual.

Getting Started

INITIAL SETUP

Language Setup
1. Press the forward or back arrow to select English, French or
Spanish.
2. Press the OK button to confirm and exit.
Date and Time Setup
1. Press the forward or back arrow to highlight the field to change.
2. Press the OK button to activate the field (field turns green).
3. Press the forward or back arrow to change the activated field.
4. Press the OK button to save changes (field turns yellow).
5. Repeat above steps to change remaining fields.
6. Press the main menu button to exit.

BASIC OPERATION

NOTE: At any time during the camera operation, pressing the main
menu button will return to the previous menu.
To Record Photos or Videos
Be sure a micro SD card (sold separately) is loaded in the card slot
(H).
1. Turn both the camera (B) and the handle set (G) on.
2. Aim camera at destination.
A. Press the camera button (L) to take a photo. A confirmation
icon will appear in the top right side of screen.
OR
B. Press the record button (M) to start recording.
A red dot will appear in the top right side of the screen.To stop
recording, press the record button again.
The camera will create a folder on the micro SD card for that day. All
photos or videos taken that day will be stored in this folder.
11