Publicidad
Idiomas disponibles
Idiomas disponibles
STOPPING
Release the switch lever.
2. hOw TO mOw
For cutting convenience, it may be best to start
mowing at a point close to the power supply
and to work your way away from the supply.
Mow the lawn at a right angle from the power
supply and place the power cable to side
which has already been cut.
NOTE: The motor is protected by a safety
cut out which is activated when the
blade becomes jammed or if the motor is
overloaded.
when this occurs stop, remove the plug
from the power supply.
Release the switch lever,
Clear any obstruction, then restart it.
If the mower cuts out again increase the
height of cut to reduce the load on the
motor.
wARNING! When mowing do not allow
the motor to labor particularly in heavy
conditions. When the motor labors the speed
of the motor drops and you will hear a change
in the motor sound, when this occurs, stop
mowing, release the switch lever and raise the
height of cut. Failure to do so could damage
12
the machine.
3. GRASS bAG FILLING INDICATOR (See
F)
To remind you immediately to empty when
the grass bag is full, the mower provides
an indicator on the top of bag to show the
collection status. And you can follow as
below:
Empty status: flap float (a)
Fully status: flap fall down (b)
4. INSTALLING mULCh PLUG (See G)
1) Unplug tool, and wait for blade to come to
a complete stop.
2) Raise the safety guard and hold it up.
3) Slide the mulching plug (12) into the
Electric lawn mower
All manuals and user guides at all-guides.com
4) Release safety guard and ensure it is
5. REmOVING mULCh PLUG (See G)
To remove the mulching plug so that you can
collect the grass follow the steps listed below:
1) Unplug tool, and wait for blade to come to
2) Raise the safety guard and hold it up.
3) Grasp the middle of the plug, lift and pull
4) The safety guard is spring loaded. When
6. REAR DISChARGE (See h)
The mower provides a rear discharge function,
so that you can mower without bag collection.
The debris will be discharged from the rear
chute.
7. wORK mODE DIAL (See I)
Status1: QUIET mode
Select QUIET mode when mowing in everyday
conditions, removing approximately 20mm of
grass at a time.
Status2: TURbO mode
Set the dial to TURBO mode when cutting
dense or overgrown grass.
8. ADJUSTING ThE CUTTING hEIGhT
(See J)
WAIT FOR BLADE TO COME TO A COMPLETE
STOP .The blades continue to rotate after the
machine is switched off, a rotating blade can
cause injury.
CAUTION: Do not touch rotating blades.
The lawn mower can be set to 6 cutting
heights between 20mm and 70mm. For this
purpose, move the cutting height adjustment
lever outwards then adjust to the preferred
position.
discharge opening until it is firmly in
contact with the deck.
properly closed.
a complete stop.
out the mulching plug completely.
you release it, the guard will return to the
closed position.
wARNING! STOP REALEASE THE
SWITH LEVER, UNPLUG TOOL, AND
EN
Publicidad
