Garland GRASS 1055 ZSH Manual De Instrucciones página 43

6.3.2.1. COLD-STARTING THE ENGINE
Place the machine on a flat and stable surface in
order to start it.
START
Place the air level in the
"START"
Push the safety switch bar until
it touches the upper handle.
Place yourself behind the mower
as shown in the figure and pull
the Starter rope until the engine
starts.
RUN
Place the air lever In the normal
working positon "RUN" .
Allow the engine to warm up for a few minutes before
starting to use the machine.
6.3.2.2. STARTING WITH A HOT ENGINE
Place the machine on a flat and stable surface in
order to start it.
Place the air lever in the normal
RUN
working position "RUN"
Push the safety switch bar until it touches the upper
handle.
Place yourself behind the mower and pull the Starter
rope until the engine starts.
position. If after a few tries the engine does not start, follow the
instructions for starting cold-starting the engine.
6.4. STOPPING THE ENGINE
6.5. TRACTION DRIVE
6.6. CHECKPOINTS AFTER STARTING THE MACHINE
It is important to pay attention to the possible
individual parts or and the temperature of the
machine. If you detect any anomaly in the machine
immediately stop and check it carefully.
In case of any malfunction or problem take the
machine to a service technician to be repaired.
Under no circumstances must you continue to use the
machine if the operation does not seem appropriate.
.
Do not use the machine if it is damaged or improperly
adjusted.
43/168
English
Turn of the engine by
releasing the safety switch.
Press the traction
handle against the
handlebar, as shown
in the figure, and the
mower traction will
start operating.