Publicidad
Idiomas disponibles
Idiomas disponibles
V. PREPARATION
WARNING :The engine does not contain oil.
a) To fill the fuel tank, start the machine and maintain the engine, see the engine instruction
book enclosed with the user manual for the machine.
b) Remove the bar support (13) from the front of the machine, attach the cutter bar to it using
the four M8 screws fixed to the cutter bar and the part (17).
Place the bar support on the bar. Insert the screws from beneath, put on the nuts and tighten
hard.
It is very important that these 4 nuts and screws are tight.
c) Fitting the handlebars:
Insert the handlebar stem (1) with the silent-bloc and U-bolt (2) onto the spacer tube.
Squeeze the silent-bloc slightly to make it easier to insert the holding rod (3), and insert the
pin (4).
Hook the clutch transmission (5) onto the handle on the right hand side and the electric cable
for the deadman's (6) handle on the left-hand side.
To adjust the height of the handlebars, slacken the two bolts (7) which hold the
flanges.Swivel the handlebars (1).
Re-tighten.
7 EN
Publicidad
