Publicidad
Idiomas disponibles
Idiomas disponibles
c) Cleaning the cutter bar : (after each use)
Remove the blade :
- Slacken the blade presses with a 17mm spanner
- Lift up the blade press
- Remove the blade.
- Clean the cutter bar, particularly the surfaces that rub together (moving and fixed).
- Check the condition of the blade. Make sure the blade strip and the sections are not bent; if
necessary straighten them.
Reassemble the blade:
- Place the blade in position.
- Lower the blade presses making sure they are correctly positioned .
- Tighten the screws using a 17mm spanner.
- Check the blade moves freely (see paragraph e)
d) Lubrication:
- Lubricate the universal joint at the grease nipple
- Lubricate the bar support tube at the grease nipple.
- Lubricate the drive support tube at the grease nipple.
- Lubricate the drive ring.
- Oil the blade.
10 EN
Publicidad
