Exchange Of The Protection Glass; Errors - Schick Dental L Protect Manual De Instrucciones Originales

6. Exchange of the protection glass pane
Excessive work on alloys can cause irreversible wear on the protection glass. If necessary the pane can be
exchanged easily. For removing the pane from the illuminated frame, remove the panel-brackets first
(pic. 5 + 6).
Pic. 5
For the installation of the new pane slide the glass into the guidance grooves at the upper frame side
and lay the pane into the frame completely (pic. 7).
Pic. 7
Fix the pane with the supplied panel brackets as shown on the picture 8.
Always use the original protection glass pane from Schick! The pane is made from safety glass and
minimizes the risk of injuries in case of breakage.

7. Errors

Error description
flickering light
no light
Cause
bad contact between illuminated
frame and clip
bad power supply
6
Pic. 6
Pic. 8
Solution
- push illuminated frame completely into the clip
- clean contacts from illuminated frame
- clean inside of the clip
- check connection from mains supply
- push illuminated frame completely into the clip
- check on/off switch position