Danby Designer DAR044A1WDD Guia Del Propietario página 9

Occasionally, a problem is minor and a service call may not be necessary- use this troubleshooting guide for a possible
solution. If the unit continues to operate improperly, call an authorized service depot or Danby's Toll Free Number
1-800-263-2629 for assistance.
PROBLEM
1) Unit does not work.
2) Unit runs continuously.
3) Internal temperature not
cold enough.
4) Ice Formation on the
inner rear wall
5) Water is leaking from the
refrigerator.
6) Noise
All manuals and user guides at all-guides.com
TROUBLESHOOTING
POSSIBLE CAUSE
• No power to unit.
• Power cord unplugged.
• Wrong voltage being used.
• Temperature set too cold.
• Door is not closed.
• Hot food has been inserted.
• Door open too long/too often.
• Close proximity to heat source or direct
sunlight.
• No power to unit.
• Power cord unplugged.
• Temperature control too warm.
• Door open too long/too often.
• Hot food inserted.
• Air flow obstruction.
• Wrong voltage being used.
• Close proximity to heat source or direct
sunlight.
• The door does not seal well.
• The door is frequently opened or left too
long.
• The food stored in the refrigerator was
warm;
• The food or dish is touching the inner
back wall.
• Water pipe is clogged and
defrost water drips over the channel.
• Appliance not level.
• Appliance not installed on a firm solid
base/floor.
• Appliance is touching a wall or kitchen
units standing next to it.
• Accessories inside the appliance are
placed incorrectly. Bottles tins and other
vessels may be touching each other
causing rattling and/or vibrations.
• Check connection of power cord to power
source.
• Plug in unit.
• Use proper voltage.
• Raise temperature settings.
• Close door securely.
• Ensure food is room temperature before
inserting.
• Reduce frequency and duration of door
openings.
• Do not place unit close to heat sources or
direct sunlight.
• Check connection of power cord.
• Plug in unit.
• Check settings, adjust if necessary.
• Reduce frequency and duration of door
openings.
• Ensure food is room temperature before
inserting.
• Allow room for air to circulate around the
unit.
• Use proper voltage.
• Do not place unit close to heat sources or
direct sunlight.
• Set the thermostat knob to OFF (0) position
and leave the door open. Never use electric
devices for defrosting and do not scrape the
ice or frost layer with sharp objects After
defrosting is complete, turn the knob to
desired position and close the refrigerator
door.
• Clean the gasket if it is contaminated, or
replace it if it is damaged.
• Clean the clogged pipe with a plastic straw,
for example.
• Manually defrost the increased ice layer. See
"Ice Formation on the Inner Wall"
• Always make sure that the appliance is
leveled and installed on a firm solid
base/floor.
• The Appliance must not touch any wall or
other kitchen units.
• Make sure the accessories inside the
appliance are correctly placed so they dont
touch each other and cause rattling and/or
vibrations.
7
SOLUTION