RIDGID R861150 Manual Del Operador página 8

ASSEMBLY
UNPACKING
This product has been shipped completely assembled.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
PACKING LIST
Hammer Drill
Auxiliary Handle Assembly
Double-ended Bit
Tool Bag
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Failure to
heed this warning could result in serious personal
injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
OPERATION
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always wear safety goggles or safety glasses with
side shields when operating products. Failure to do
so could result in objects being thrown into your
eyes resulting in possible serious injury.
WARNING:
To prevent accidental starting that could cause
serious personal injury, always remove the battery
pack from the product when assembling parts.
INSTALLING/REMOVING THE AUXILIARY
HANDLE
See Figure 2, page 14.
The drill is equipped with an auxiliary handle assembly that
can be mounted on either side.
To install the auxiliary handle:
 Insert the hex bolt through the hole on the drill.
 Thread the auxiliary handle onto the end of the bolt and
tighten the handle by turning it clockwise. Make sure the
handle is secure before beginning operation.
To remove the handle and install it on the opposite side:
 Turn the handle counterclockwise to loosen and remove
the handle and hex bolt.
 Insert the hex bolt through the hole on the drill. Thread
the auxiliary handle onto the end of the bolt and tighten
the handle by turning it clockwise.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Hammer drilling in concrete, brick, or other masonry
 Drilling in wood
 Drilling in ceramics, plastics, fiberglass, and laminates
 Drilling in metals
 Driving screws
 Mixing paint
8 - English