Bond HYPH4601-2 Manual Del Usuario página 7

ASSEMBLY INSTRUCTIONS
1. Flip the tank housing (D) upside down and
attach the wheel assembly (J) to the base of the
tank housing (D) using 2 M8 x 16 screws (CC).
2 2 . To add additional ballast and weight to
the base, open the door of the tank housing
(D). Remove the plastic plug at the center of
the base, then pour 7.5 kgs of sand
(approximately 3/4 of the cavity) through the
hole at the center of the base. Once sand is
placed, fill the hole with water until water
reaches the top of the rim. Insert the plug
into the hole tightly; Clean any additional
spilled sand and water.
3. Attach the tank housing supporter (G) into the
tank housing (D) using 1 M8 x 16 screw (CC) and
2 M5 x 12 screws (AA). Do not fully tighten to
allow room for adjustment later in the assembly
process.
All manuals and user guides at all-guides.com
CC
J
D
1-866-771-2663 | Page 7
Water
Sand