Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
Park Brake
Visually check that no damage is found on the
lever, links, or switch belonging to the park brake.
Perform a standstill test and check that there is
sufficient braking.
WARNING! Faulty adjustment will result
in reduced braking ability and can cause an
accident.
Park Brake Adjustments
1. Using a jack stand, raise the rear of the
mower up off the ground. Make sure the
machine is securely supported.
2. Remove the rear tire assemblies.
3. Release the park brake.
4. Measure the distance from the swivel to the
washer. The measurement must be 1-3/4"
on both the right and left side brake linkage
assemblies.
5. If adjustments are needed, loosen B jam nut
and turn A jam nut until the correct distance
is achieved. Retighten B jam nuts against A
jam nuts.
D
A
6. Engage the park brake. Measure the distance
between the D brake bolt and the brake
swivel. The distance must be 1/8"-1/4".
7. If adjustments are needed, loosen C jam
nut. Turn the brake bolt until the distance is
correct. Retighten C jam nuts.
B
C
Caster Wheels
Check every 200 hours. Check that wheels rotate
freely.
To replace, remove nut and caster bolt. Pull the
wheel out of the fork. Install in reverse order.
Tighten caster bolt. Torque to 45 ft-lbs (61 Nm),
then back nut off 1/2 turn.
NOTE: Tire should rotate freely but axle spacers
should not. If wheels do not rotate freely take the
unit to the dealer for service.
Spark Arrestor
Clean the interior screen regularly, depending on
usage and conditions.
To clean, remove the clamp securing the tail pipe.
Remove the tail pipe and slide the spark arrestor
screen out of the muffler. Clean carbon from the
screen with a soft brush or cloth.
Replace screen and reattach the tail pipe,
orienting the tail pipe either horizontally or
upwards, away from grassy surfaces.
Cleaning
Regular cleaning and washing, especially under
the mower deck, will increase the machine's life-
span. Make it a habit to clean the machine directly
after use (after it is cooled), before the dirt sticks.
Do not spray water on the top of the mower deck.
Use compressed air to clean the top side of
mower deck. Regularly clean deck and underside
of the deck with normal water pressure. Do not
use a high pressure washer or steam cleaner.
Avoid spraying engine and electrical components
with water.
Do not rinse hot surfaces with cold water. Let unit
cool before washing.
CAUTION! Always wear eye
protection when cleaning and
washing.
Hardware
Check daily. Inspect the entire machine for loose
or missing hardware.
27
Publicidad
