Publicidad
Idiomas disponibles
Idiomas disponibles
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM
Handle not in position.
Snow blower not starting.
The motor is on but the impeller does
not turn.
After passing, the snow blower leaves
a layer of snow on the ground.
TROUBLESHOOTING
POSSIBLE CAUSE
Handle adjustment knobs and/or handle
lock clips are not secured.
Battery is low in charge.
Start button is not depressed.
The drive belt is worn or broken.
The impeller/scraper mechanism is
worn.
MAKE THE MOST OF YOUR PURCHASE!
Go to http://register.ryobitools.com and register your new tool on-line.
Your product has been fully tested prior to shipment
to ensure your complete satisfaction.
For any questions about operating or maintaining
your product, call the Ryobi Help Line!
12 — English
SOLUTION
Make sure handle adjust knobs are
fully seated and handle lock clips are
fully closed.
Charge the battery.
Press start button.
Have the drive belt replaced by an au-
thorized service center.
Have the impeller/scraper mechanism
replaced by an authorized service
center.
Publicidad
