Activates Mode Selected
Rotate outer ring to
access desired mode.
Chromatherapy - Specific Color
Lighted User Keypad
Available modes will be illuminated in blue. Active modes will be illuminated in green.
Turns the whirlpool pump on and off. Icons illuminated in blue indicate available
Power
modes/features. Modes which are operating will be illuminated in green.
Outer Ring
Rotate the outer ring to the desired mode. The selected mode will flash blue.
OK
Activates the desired mode.
Up Arrow
Increases the water flow when the Flexjet flow mode is active.
Indicator Bar
Displays the water flow volume in the Flexjet flow mode.
Effervescence
Ports activate to provide a gentle, soothing bubbling action.
Mode
Decreases the water flow when the Flexjet flow mode is active.
Down Arrow
Chromatherapy
Chromatherapy lights will automatically and continuously cycle through the eight colors:
Cycle
white, violet, indigo blue, aqua blue, green, yellow, orange, and red. One cycle through all
eight colors takes approximately one minute.
Heater
Automatically engages when the power icon is selected. Rotate the outer ring until the
heater mode is flashing, then press OK to turn the heater off. Press OK again to turn the
heater back on.
Chromatherapy -
Press OK to activate, then use the up or down arrow to reach the desired color. Press OK
Specific Color
while the chromatherapy cycle is active to turn off the chromatherapy lights.
Operation
NOTE: If the whirlpool is not operating properly, consult the "Troubleshooting" section of this guide
before calling a qualified service representative.
Whirlpool
NOTICE: Do not allow the water temperature in the whirlpool to exceed 104°F (40°C). The heater will
automatically maintain the water temperature when the whirlpool is running, as long as the water
temperature does not exceed 104°F (40°C). The heater will disengage at higher temperatures.
Close the drain, then fill the whirlpool to a level at least 2" (5.1 cm) above the highest effervescent
port. Using your hand, test the water temperature for comfort and safety. Carefully enter the bath.
Press the power icon to turn on the whirlpool pump and heater. Water will flow at medium volume.
Press the up or down arrow icons to increase or decrease the water flow. The indicator bar will
display the water flow volume.
If desired, turn the heater off by pressing the heater icon. Press the button a second time to turn the
heater back on.
Kohler Co.
All manuals and user guides at all-guides.com
Power On/Off
Increases Flow or Pulse
Indicator Bar
Effervescence Mode
Decreases Flow or Pulse
Chromatherapy Cycle
Heater On/Off
5
1023246-5-C