GreenWorks G24LT30 Manual Del Operario página 10

6.3 REPLACE THE SPOOL
Figure 17 - 19.
1. Simultaneously press the tabs on the sides of the trimmer
head.
2. Pull and remove the spool cover.
3. Remove the spool.
4. Replace with a new spool.
Make sure that the cutting line is in the guide slot on the
new spool, and is extended approximately 13 cm. before
you install the new spool.
5. Put the end of the cutting line through the eyelet.
6. Extend the cutting line to release it from the guide slot in
the spool.
7. Push the tabs and install the spool cover onto the spool
housing.
8. Push the spool cover until it clicks into position.
6.4 REPLACE THE CUTTING LINE
Figure 20 - 22.
NOTE
Remove the remaining cutting line on the spool.
Use only with the nylon cutting line of 1.65 mm diameter.
1. Cut a piece of cutting line approximately 3 m long.
2. Bend one end of the line approx. 6 mm.
3. Insert the line into the anchor hole of the spool.
4. Wind the cutting line around the spool tightly in the
indicated direction.
5. Put the cutting line in the guide slot.
6. Do not wind the cutting line beyond the edge of the spool.
7 TRANSPORTATION AND
STORAGE
WARNING
Remove the battery pack from the machine before
transportation and storage.
7.1 MOVE THE MACHINE
When you move the machine, you must:
• Wear gloves.
• Stop the machine.
• Remove the battery pack and charge it.
• Assemble the blade guard.
NOTE
NOTE
English
7.2 STORE THE MACHINE
• Remove the battery pack from the machine.
• Make sure that children cannot access the machine.
• Keep the machine away from corrosive agents such as
garden chemicals and de-icing salts.
• Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine for any
damage.
8 TROUBLESHOOTING
Problem Possible Cause
The ma- No electrical con-
chine does tact between the
not start machine and the
when the battery pack.
trigger is
pushed.
The battery pack is
depleted.
The lock-out but-
ton and trigger are
not pushed at the
same time.
7
Solution
1. Remove battery pack.
2. Check contact and in-
stall the battery pack
again.
Charge the battery pack.
1. Pull the lock-out but-
ton and hold it.
2. Pull the trigger to start
the machine.
EN