Cleaning Mode Selection; Spot Cleaning Mode - ECOVACS ROBOTICS DEEBOT R96 Manual De Instrucciones

3.3 Cleaning Mode Selection

DEEBOT has several Cleaning Modes to choose from to effectively clean different floors. Cleaning
Modes are selected using the ECOVACS App or using the AUTO Mode Button on the robot's Control
Panel. For more information on the ECOVACS App, see the separate ECOVACS App leaflet.
1 AUTO Cleaning Mode
This is the most commonly used mode. In AUTO Cleaning Mode, DEEBOT cleans in a back and
forth straight-line pattern.
To start AUTO Cleaning Mode, press the
AUTO Mode Button on the robot or
the App.
2

Spot Cleaning Mode

This mode is applicable for an area of highly concentrated dirt or dust. In Spot Cleaning Mode,
DEEBOT focuses on a specific area to clean and returns to the Charging Dock once the Spot
Cleaning is completed.
To start Spot Mode Cleaning, press
spot and a 1m/3.2' area around the spot.
3 Area Cleaning Mode
After DEEBOT has scanned and mapped the environment, specific areas on the map can be selected
to be cleaned using Area Cleaning Mode. Area Cleaning Mode can only be selected using the App.
To set or discard cleaning areas, press
* DEEBOT can only recognize a room with doorway ranging from 40cm (1.3') to 160cm (5.2')
and perimeter larger than 8m (26.2').
3. Operating and Programming
on
on the App's map screen. DEEBOT cleans the selected
on the App's map screen.
15
EN