Cebora 388 Manual De Instrucciones página 27

kept as long as the welding torch trigger is pressed again.
When the torch trigger is pressed again, the welding cur-
rent will connect to the crater filling current and it will be
maintained until the torch trigger is released.
To adjust the values of the Start current, of the connec-
tion time and of the crater filling current enter the Main
Menu with key F MENU and enter the process parame-
ters menu.
Turn knob 2 to select the parameter, press it to enter the
regulation screen and turn it to adjust the value.
Press the key DEF to reset the factory set parameters.
D
Inductance.
0.0
The adjustment can vary from -9.9 to +9.9. Zero is the
number set by the factory: if the number is negative, the
impedance decreases and the arc becomes harder; if in-
creased, it becomes softer.
To enter the function select it with your finger. To adjust
the value just turn the knob 2.
E
Arc Correction.
0.0
To modify the arc length select it with your finger. To ad-
just this value just turn the knob 2.
F
Menu.
MENU
To use this function select it with your finger.
By selecting it you enter the Main Menu.
3300510/D
SELECTION OF THE WELDING PROCESS
Process
MIG, TIG OR MMA.
After having selected the MIG
knob 2 you can select the arc transfer type: MIG Pulse,
MIG Short and MIG Manual.
To confirm the selection press knob 2 or the key
SELECTION OF THE WIRE TYPE, DIAME-
Material
TER AND WELDING GAS.
To confirm the selection press knob 2 or the key
Parameters PROCESS PARAMETERS SELECTION.
• Arc length correction.
Turn knob 2 to select the parameter and confirm the
selection by pressing the same knob.
The value is adjusted by turning the knob 2.
To confirm the selection press knob 2 or the key
Press the key DEF to reset the factory set parameters.
• Inductance Correction.
Turn knob 2 to select the parameter and confirm the
selection by pressing the same knob.
, welding process with
.
.
.
27/36