Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS (Continued)
5.
Attach one end of each of the water supply lines
onto the shanks (5.1) on the faucet body (B), with
hot water on the left and cold water on the right.
Use 1/2 in. IPS faucet connections (5.2) or supply
line coupling nuts (5.3) with 3/8 in. OD ball-nose
risers (5.4). NOTE: Do not reuse existing supply
lines. When installing new water supply lines,
please refer to the supply line manufacturer's
installation instructions. Tighten the supply line
connections using an adjustable or basin wrench.
Do not overtighten.
6.
Separate the weight (E) into two pieces using a
screwdriver. At the location indicated, attach the
two pieces of the weight (E) around the sprayer
hose (D) using the screwdriver.
Connect the sprayer hose nut (6.1) to the sprayer
outlet (6.2). Tighten, but do not overtighten.
7.
Attach each of the remaining ends of the water
supply lines (7.1) to the hot and cold water shut-
off valves (7.2) and tighten with a wrench. Do not
overtighten.
8.
Once the installation is complete, remove the
aerator assembly (8.1) from the spray head (A).
Do not lose the gasket from inside the aerator.
Turn on the water supply and allow both the hot
and cold water to run for at least one minute to
flush away any debris that could cause damage
to internal parts. While the water is running, check
for leaks. If a leak occurs, gently tighten the nut on
the connection that is leaking.
Turn off the water, reinsert the gasket, and screw
the aerator (8.1) back onto the spray head (A).
5
5.2
6
E
7
8
10. 1
A
5
5.1
5.4
5.3
6.2
6.1
D
7.1
7.2
A
8.1
Publicidad
