Machine Start And Stop - Advance SC450 Instrucciones De Uso

For cleaning machines, parts & supplies click/visit www.southeasternequipment.net
ENGLISH
Solution tank filling
CAUTION!
Use only low-foam and non-flammable detergents, intended for automatic scrubber applications.
WARNING!
When using floor cleaning detergents, follow the instructions on the labels of the detergent bottles.
To handle floor cleaning detergents, wear suitable gloves and protections.
9. Use the filler neck (31) or the removable filler hose (40, optional) to fill the tank (15) with a solution suitable for the work to be
performed. Do not fill the solution tank completely, leave few inches from the edge. Always follow the dilution instructions on
the label of the chemical product used to prepare the solution. The solution temperature must not exceed 104 °F (40 °C).

MACHINE START AND STOP

Starting the machine
1. Prepare the machine as shown in the previous paragraph.
2. Drive the machine to the working place by pushing it with the hands on the handlebar (2).
3. Lower the squeegee (21) with the lever (7).
4. Turn the solution flow control lever (36) to one of the following positions, according to the type of cleaning to be performed:
• ECO system: when the lever (36) is turned to ECO position (37), the machine works in a special condition of programmed
water "economy" usage; as the water flow is set and constant, the machine can work with a washing autonomy of ~ 90
minutes [0.10 gpm (0.4 liters/min) average].
• Variable system: when the lever is turned to the left (variable flow) the flow rate can increase up to 0.42 gpm (1.6 liters/min)
(when the tank is full), with an autonomy of ~ 40 minutes.
5. Press the brush/pad-holder switch (41) and the vacuum system switch (42).
6. Press the push-button (47) to enable the brush/pad-holder.
7. Start cleaning, by moving the machines with the handlebar (2).
NOTE
If the green LED (44) turns on, the machine is ready to be used. If the yellow or red LED (45 or 46) turns on, the batteries
must be charged (see the procedure in Maintenance chapter).
Stopping the machine
8. Stop the machine and the brush/pad-holder by releasing the push-button (47).
9. Turn off the brush/pad-holder and the vacuum system by pressing the switches (41) and (42).
10. Lift the squeegee (21) with the lever (7).
11. With the handlebar (2) slightly lower the machine until the rear wheel (6) comes into contact with the floor (parking position
(27)).
14
For cleaning machines, parts & supplies click/visit www.southeasternequipment.net
INSTRUCTION FOR USE
SC450 - 9099602000
8/12